This device is intended for testing servos. It is very helpful to install servos in new model, when there is no timer yet. I use it also for assembling electronic tow hooks.

It generates PWM (Pulse Width Modulation) signal to control servo position. There is a large potentiometer for fine trim. Besides you can perform jump move between center and marginal deflections. PWM parameters are adjustable and stored in EEPROM memory.

The construction is similar to Setuper 2. But there is 4 cells NiMH accumulator as power supply instead of 9V battery in Setuper 2.

General Features

2-line LCD display.
Power supply: 4 cells NiMH accumulator.
Fine trim by potentiometer, jump move by buttons.
Adjustable PWM parameters.

Optimalized for Mozilla Firefox 3.

Visited times since 2003.

Last update: 29-06-2010.